Ninjaflex Extruder Mod – Fail

20180409_Ninjaflex Mod

This is a short little update following on from my last post attempting to 3D print with Ninjaflex filament (soft TPU):

After limited success using the stock extruder on a Wanhao Duplicator i3, I found a 3D printable Extruder Drive Block on Thingiverse to supposedly help stop the filament from finding its way out out the back rather than being forced down into the nozzle. Well, as you can see from the photos, it looks like it fits quite well, although I did have to slice and file a few areas to fit properly – most notably around the shaft of the stepper motor which was far too tight and stopped it from turning, and the wheel that pushes the filament against the stepper gear which was blocked from putting any force against the filament so did not drive it down into the nozzle. Admittedly, the file on Thingiverse was designed for the Duplicator 4, so it was a bit of a long shot to work with the i3.

So back to the drawing board I’m afraid for Ninjaflex printing – perhaps time to upgrade to a Flexion extruder, or look at some other TPU materials that might be slightly stiffer and more suitable for this basic extruder. Flexible PLA looks interesting. If you’ve had any successes 3D printing with Ninjaflex on a printer like the Duplicator i3, leave me a comment 🙂

– Posted by James Novak

Advertisements

One thought on “Ninjaflex Extruder Mod – Fail

  1. Pingback: Ninjaflex Part 3 – Flexion Extruder Upgrade | edditive blog

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s