Excuse the headline pun, but this post is all about 3D printing using a brim, which evidently can really improve your success rate with large flat surfaces.
For those not familiar with a brim, it’s an option in some 3D print software (such as Cura) that lays down an extra width of material around your object and attached to it, one or two layers tall. You can see the brim around my enclosure in the top left image. Essentially this extra material creates a stronger bond to the build plate, helping to fight the contracting forces of the cooling plastic that can commonly cause warping. Of course there are many other ways to combat this, including laying down some glue or adhesive spray, printing the part in a different orientation, or using an enclosure to keep the print warmer so there is less warping from rapidly cooling plastic. However these aren’t always an option, so using a brim can be a really effective solution that only wastes a very small amount of extra material.
In the top right image you can see my first attempt at printing this enclosure half, which is very clearly warped as the outer edges lifted up from the plate under the contracting forces of the cooling plastic. Support material was used, but nothing else. In contrast, you can see the middle image which is the end result once the brim from the left image was removed – perfectly horizontal! This is really important for this design since it is one half of an enclosure, and the warped version simply won’t fit properly with the other half.
It’s certainly not something needed for every print, but for large surfaces it’s proving to be very successful. If you’ve had similar problems with warping and haven’t tried a brim yet, it’s worth giving a go – you can see where to access this setting if you are using Cura on the left, very easy, or if you are using another program to slice and print, have a look through your settings. The raft is another option you may have used, however the raft builds up a lot more material underneath your entire object which is wasted. It can also be a good option though, especially if you are using a printer like the Up Plus 2 which does not have the option of printing a brim but will do a good job with a raft.
– Posted by James Novak